f,,
<))
CD DIGITALOUT
(OPTICAL)
)
[~)
&
VIDEO/AUX
MD
LINEOUT
m
JI
SURROUND
,?SPEAKERS
uWI
Refer to the operatinginstructionsofthe connected equipment
fordetails.
lTheconnecting cords are not supplied.Obtain the necessary
connecting cords.
lConsultyourlocalAiwadealerforoptionalequipment.
To playa equipment connected toVIDEO/AUXjacksorMD jacks
proceed as follows.
VIDEO/AUX JACKS
1 Press VIDEO/AUXor MD.
This unitcan inputanalog sound signalsthrough these jacks.
To ~lav the equipment connected to VIDEO/AUX,press
Use a cable withRCA phono plugs toconnect audio equipment
VIDEO/AUX.?VIDEO? appears on the display.
(turntables,LD players,MD players,VCRs, TV, etc.).
To ~lav the equipment connected to MD, press MD. ?MD?
Connect the red plug to the VIDEO/AUXR jack,and the white
appears on the display.
plug tothe VIDEO/AUXL jack.
2 Play the connected equipment.
Whenconnecting a turntable
Use an Aiwa turntableequipped witha built-inequalizeramplifier.To change a source namein the display
When VIDEOIAUXispressed, ?VIDEOisdisplayed initially.It
can be changed to ?AUX or ?TV?.
MD JACKS
With the power on, press POWERwhilepressingVIDEO/AUX.
This jack isrecommendedtoconnect withan MD player.Repeat the procedure to selectone ofthe names.
Use a cable with RCA phono plugs.
To adjust the sound level of the external source
Connect the red plugtothe MD R jack,and thewhite plugtothe
MD L jack.When the sound levelof the externalsource ismuch higheror
much lowerthanthatofotherfunctionsources,adjustitas follows.
1 Press VIDEO/AUXor MD and playthe equipment.
2 Press +or *sothatthe sound levelbecomes the same
as thatofotherfunctionsources.
This unitcan outputanalog sound signalthrough these jacks.
Use a cable with RCA phono plugs toconnect audio equipment
with LINE IN (analog input)jacks.m
Connect the red plug of a cable to LINE OUT R jack,and theDuring recording,the sound levelcan not be adjusted
white plug to LINE OUT L jack.
m
Do not connect an equipment to LINE OUT jacks and VIDEO/
AUX jacks simultaneously.Otherwise, noise isgenerated and
malfunctionoccurs.
This unitcan output CD digitalsound signalsthrough thisjack.
Use an opticalcable to connect digitalaudio equipment (DAT
deck, MD recorder,etc.).
Remove the dust cap @ from the CD DIGITAL OUT (OPTICAL)
jack.Then, connect an opticalcable plug to the CD DIGITAL
OUT (OPTICAL) jack.
Whenthe CD DIGITAL OUT (OPTICAL)jack is not being
used
Attach the supplieddust cap.
Connect optionalsurround speakers withthe8 ohms to 16 ohms
impedance tothe jacks,
25ENGLISH |