IC, LC78622E
Pin No.Pin NameI/ODescription
1DEFIIDefect sense signal (DEF) input pin. (Connect to 0V when not used).
2TAIITest signal input pin with built-in pull-down resistor. Be sure to connect to 0V.
3PDOOPhase comparator output pin to control external VCO.
4VVSSNGND pin for built-in VCO. Be sure to connect to 0V.
For PLL.
5ISETIPin to which external resistor adjusting the PD0 output current.
6VVDDNPower supply pin for built-in VCO.
7FRIPin for VCO frequency range adjustment.
8VSSNDigital system GND. Be sure to connect to 0V.
9EFMOOEFM signal output pin.
For slice level control.
10EFMINIEFM signal input pin.
11TEST2ITest signal input pin with built-in pull-down resistor. Be sure to connect to 0V.
12, 13CLV+, CLV�ODisc motor control output. Three level output is possible using command.
___Rough servo or phase control automatic selection monitoring output pin. Rough servo
14V/PO
at H. Phase servo at L.
15HFLITrack detect signal input pin. Schmidt input.
16TESITracking error signal input pin. Schmidt input.
17TOFFOTracking OFF output pin.
18TGLOTracking gain selection output pin. Gain boost at L.
19, 20JP+, JP�OTrack jump control signal output pin. Three level output is possible using command.
21PCKOEFM data playback clock monitoring pin 4.3218 MHz when phase is locked in.
Sync signal detection output pin. H when the sync signal which is detected from EFM
22FSEQO
signal and thesync signal which is internally generated agree.
23VDDNDigital system power supply pin.
The pin is controlled by the serial data
command from microprocessor. When
the pin is not used, set the pin to the input
24-28SL+ - PUINI/OGeneral purpose input/output pin 1 to 5.
terminal and connect to 0V, or alternately
set the pin to output terminal and leave
the pin open.
29EMPHODe-emphasis monitor output pin. De-emphasis disc is being played back at H.
30C2FOC2 flag output pin.
31DOUTODIGITAL OUT output pin. (EIAJ format).
32, 33TEST3, TEST4ITest signal input pin with built-in pull-down resistor. Be sure to connect to 0V.
34N.C.NNot used. Set the pin to open.
35MUTELOL-channel mute output pin.
36LVDDNL-channel power supply pin.
L-channel 1-bit DAC.
37LCHOOL-channel output pin.
38LVSSNL-channel GND. Be sure to connect to 0V.
39RVSSNR-channel GND. Be sure to connect to 0V.
40RCHOOR-channel output pin.
R-channel 1-bit DAC.
41RVDDNR-channel power supply pin.
42MUTEROR-channel mute output pin.
16 |